Post by scornflake on May 24, 2022 5:53:39 GMT
I recently changed some groups from 'Normal' to 'Looped chain', and also added about a 6s cross fade on all items within the group using bulk edit. This was done with MA 2022 1.0.1.
Now they don't seem to play their audio.
Well, it *does* play (shows green in the group), but seems stuck at 0%.
Any tips here?
Audio is triggered by an Ambient Sound script like so:
Also I note that all the audio items of the audio group (in the inspector) are disabled, including the one that's supposed to be being played.
If I reconfigure the audio group:
1. put mode back to 'Normal' instead of loop chain
2. re-enable loop-clip on all items inside the group
it then works again (albeit always looping the sounds, where I was hoping to get variants over time by enabling loop-chain)
Now they don't seem to play their audio.
Well, it *does* play (shows green in the group), but seems stuck at 0%.
Any tips here?
Audio is triggered by an Ambient Sound script like so:
Also I note that all the audio items of the audio group (in the inspector) are disabled, including the one that's supposed to be being played.
If I reconfigure the audio group:
1. put mode back to 'Normal' instead of loop chain
2. re-enable loop-clip on all items inside the group
it then works again (albeit always looping the sounds, where I was hoping to get variants over time by enabling loop-chain)
